The Leader in Mustang Performance Suspensions

More Information

MM News

New! Expanded FAQ pages are now posted for 1979-04 Mustang camber plates and 2005-14 Mustang camber plates.

PayPal is now accepted when purchasing on the MM website.

NEW! Bumpsteer kit for 2011+ Mustangs is now available. Designed specifically for installation with the new electric power steering rack.

NEW! MM's redesigned steering shaft for 1979-93 Mustangs fits Flaming River's new design manual steering racks.

NEW! H&R rear springs for the Shelby Mustang GT500 are now available. This pair of rear springs will lower only the rear of your GT500, reducing the excessive rake of stock ride height.

NEW! MM now has 2011+ Caster/Camber Plates specifically designed to fit the 2011+ Mustangs. They provide the necessary alignment adjustability required for performance suspension tuning that was already available for 2005+ Mustangs, but are designed specifically for 2011 Mustang springs and struts.

Home :: Mustang Suspension :: Mustang Front Suspension :: Low Profile Control Arm Bolts :: Front Control Arm Bolts, Low Profile (pair)

Front Control Arm Bolts, Low Profile (pair)

Actual product may differ from photo.

$29.97

Part # MMF-2

Manufacturer: Maximum Motorsports

Add to Cart:

Maximum Motorsports Low Profile Front Control Arm Mounting Bolts, fits 1979-2004 Mustangs

The rounded contour and low profile head of these Maximum Motorsports designed front control arm pivot bolts improves clearance to the rubber steering rack boot. This in turn allows mounting the steering rack further rearwards, closer to the K-member. The further rearward the steering rack is located, the greater the Ackerman steering geometry effect. Increased Ackerman effect quickens steering response at turn-in and reduces understeer.

Direct replacement for the forward-most front control arm pivot bolts. Reuses the stock hex nuts. Requires a Torx tool, size T-55, to hold while tightening the nut. Coated with OEM quality corrosion inhibitor. Grade 10.9.