The Leader in Mustang Performance Suspensions

Adjustable Brake Proportioning Valve

$42.97

  • Part # BPV-1

  • Manufacturer: Wilwood

Add to Cart:



Brake Proportioning Valve for adjusting brake bias

This product fits
  • Direct bolt-in fitment on 1979-93 Mustang
  • Fitment for other Mustang years requires adapter fittings or cutting and flaring of the rear brake hard line.
Benefits
  • Allows adjusting the hydraulic pressure to the rear brakes.
  • Adjusting the rear line pressure alters the force applied by the rear brakes.
  • Allows more precisely balancing the proportion of rear brake, relative to the front brakes.
  • Extremely helpful when swapping brakes from one model/year to another.
Product Features
  • Designed and manufactured by Wilwood.
  • Direct fit for inverted flare brake lines with 3/8-24 tube nuts
  • Direct fit in rear brake line of 1979-93 Mustang: No adapters needed
  • Adjust pressure by rotating the knob.
  • Provides very fine adjustment increments.
Required
Installing an adjustable proportioning valve requires removing or disabling the stock brake proportioning valve. There are two ways to do so:
  1. Remove the stock valve with MM's Brake Proportioning Valve Eliminator Kit (MMBAK-6)
  2. Disable the stock valve by removing the internals and replacing the stock valve's plug with the MM-2450-A solid plug.
Notes
  • Wilwood states this valve is intended for off-highway application only.
  • Brake fluid will be required when bleeding the brakes after installation.
  • An adjustable valve means that you must adjust your Mustang's brake bias after installation. Do so at low speeds in a safe area.

© Maximum Motorsports, Inc.   3430 Sacramento Dr., Unit D   San Luis Obispo, CA 93401   (888) 378-8830

Your IP Address is: 23.20.196.179   |   Powered by Zen Cart